Detonation synthesis nanodiamonds for reinforcing metal matrix composite coatings operated under shock load

V.A. Popov; L.S. Belevsky; A.L. Chuvilin; U. Kaiser; I.I. Khodos; A.S. Prosviryakov; M.N. Kovalchuk

doi:doi:10.1051/dymat/2009159

All issues

Volume 2 (2009)

10.1051/dymat/2009159

Abstract

Issue		DYMAT 2009 Volume 2, 2009 DYMAT 2009 - 9th International Conference on the Mechanical and Physical Behaviour of Materials under Dynamic Loading


Page(s)		1139 - 1144
Section		Micro-Structural Effects
DOI		https://doi.org/10.1051/dymat/2009159
Published online		15 September 2009

DYMAT 2009 (2009) 1139-1144
DOI: 10.1051/dymat/2009159

Detonation synthesis nanodiamonds for reinforcing metal matrix composite coatings operated under shock load

V.A. Popov¹, L.S. Belevsky², A.L. Chuvilin³, U. Kaiser³, I.I. Khodos⁴, A.S. Prosviryakov¹ and M.N. Kovalchuk⁴

¹ Moscow Institute of Steel and Alloys, Russia
² Magnitogorsk State Technical University, Russia
³ Ulm University, Germany
⁴ Institute of Microelectronics Technology of RAS, Chernogolovka, Russia

Published online: 15 September 2009

Abstract
The paper is about the development of the coating from metal matrix composites with nanodiamond reinforcing particles to be applied for hard conditions including shock impacts. The main problem of using nanodiamonds in production of composites is their agglomeration, i.e., aggregation of primary nanodiamond particles 4–6 nm in size into agglomerates of up to 100 nm to 10 μm. Application of mechanical alloying for producing composites allows to obtain uniform distribution of separate initial nanodiamond particles inside copper matrix. Friction plating was applied for deposition of composite coatings. Deformation tests show that coatings applied by friction plating have high adhesion to substrate.