EPJ Web Conf.
Volume 183, 2018DYMAT 2018 - 12th International Conference on the Mechanical and Physical Behaviour of Materials under Dynamic Loading
|Number of page(s)||6|
|Published online||07 September 2018|
Comparison of Stress-induced Martensitic Transformation Under Tension and Compression in Fe-28Mn-6Si-Cr Shape Memory Alloy
Graduate School of Engineering, Hiroshima University,
1-4-1 Kagamiyama, Higashi-Hiroshima,
2 Institute of Engineering, Hiroshima University, 1-4-1 Kagamiyama, Higashi-Hiroshima, Hiroshima, Japan
* Corresponding author: firstname.lastname@example.org
Published online: 7 September 2018
In the case of the NiTi alloy, some research works reported that the stress-strain curve differs significantly between tension and compression. It is considered that the difference in stress-induced martensitic transformation behavior may be observed under different loading modes in Fe-based shape memory alloy (Fe-SMA), which is less expensive compared with the widely-used NiTi alloy. In this study, both tensile and compressive tests of Fe-28Mn-6Si-5Cr shape memory alloy, which is one of Fe-SMA, are conducted under quasi-static and impact deformation at various strain rates. During deformation, it is attempted to evaluate the stress-induced martensitic transformation by measuring the volume resistivity as well as temperature for increasing a reliability of the alloy. Furthermore, from the results of volume resistivity at each strain rate, the strain rate sensitivity of stress-induced martensite under tensile and compressive tests is investigated. Additionally, the difference in stress-induced martensitic transformation under tension and compression is studied.
© The Authors, published by EDP Sciences, 2018
This is an Open Access article distributed under the terms of the Creative Commons Attribution License (http://creativecommons.org/licenses/by/4.0), which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.