| Issue |
EPJ Web Conf.
Volume 183, 2018
DYMAT 2018 - 12th International Conference on the Mechanical and Physical Behaviour of Materials under Dynamic Loading
|
|
|---|---|---|
| Article Number | 02005 | |
| Number of page(s) | 6 | |
| Section | Experimental Techniques | |
| DOI | https://doi.org/10.1051/epjconf/201818302005 | |
| Published online | 07 September 2018 | |
https://doi.org/10.1051/epjconf/201818302005
Behaviour of UHPFRCs in compression under high stress-rates
DynaMat Laboratory, University of Applied Sciences of Southern Switzerland,
6952
Canobbio,
Switzerland
* Corresponding author : This email address is being protected from spambots. You need JavaScript enabled to view it.
Published online: 7 September 2018
Abstract
The paper presents the results obtained on cylindrical Ultra High Performance Fibre Reinforced Concrete specimens with diameter of 30mm and a height of 60mm under compression at high stress rate (1.7–2.3 TPa/s). Four different percentages of fibre reinforcement are considered (1, 2, 3, and 4% fibre content) and compared with the results of the matrix (UHPC). A slight reduction of the strength and fracture time with the introduction of fibres is observed. The experimental results are analysed and discussed with the intent to better understand the mechanical behaviour of UHPFRC materials in case of dynamic event under service loading conditions.
© The Authors, published by EDP Sciences, 2018
This is an Open Access article distributed under the terms of the Creative Commons Attribution License (http://creativecommons.org/licenses/by/4.0), which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.