EPJ Web of Conferences
Volume 94, 2015DYMAT 2015 - 11th International Conference on the Mechanical and Physical Behaviour of Materials under Dynamic Loading
|Number of page(s)||5|
|Section||Modeling and Numerical Simulation|
|Published online||07 September 2015|
Perforation of welded aluminum extrusions
Numerical prediction and experimental validation
1 Structural Impact Laboratory (SIMLab), Department of Structural Engineering, Norwegian University of Science and Technology, NO-7491 Trondheim, Norway
2 Hydro Aluminium, Research and Technology Development (RTD), NO-6601 Sunndalsora, Norway
a Corresponding author: firstname.lastname@example.org
Published online: 7 September 2015
A purely numerical procedure for predicting the perforation resistance of welded extruded AA6082-T6 aluminum profiles is presented in this study. The numerical work was conducted completely independent of the experimental tests that were only used for validation purposes. The outline of the three-step numerical procedure is as follows: (1) the temperature development due to a specified welding process is predicted by a thermal solver, (2) based on the chemical composition of the alloy, the temperature-time history during aging and the welding analysis, the yield strength and flow stress of the material were determined; and (3) the ballistic limit velocity is found using explicit finite element simulations. The experimental validation program is described and it shows that the ballistic limit velocities found from the impact experiments correlate closely with the numerically predicted values obtained without any physical material or component tests. Further, welding of the 10 mm thick extrusions gives a 10% degradation of the capacity in terms of ballistic limit velocity compared to the unaffected material.
© Owned by the authors, published by EDP Sciences, 2015
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.